User's Manual

Disconnect the BS-C26 from the power supply as soon as the baery is fully charged,
overcharging would reduce the service life of the baery. A charged baery will lose its
capacity if it is not used on a regular basis.
Important: Ensure that the baery is fully charged if you do not use the device for a long
period of me. To avoid a complete discharge of the baery, the BS-C26 should be
charged at least once every 6 months.
Charging Your Speaker
The BS-C26 speaker is powered by an internal rechargeable baery. Charge the baery
completely before its first use. Read the secon tled "Baery informaon" in this manual
before starng the charging process.
1. Connect one end of the included USB Charging Cable to your speaker's charging port.
2. Connect the other end of the USB Charging Cable to a USB port.
3. When your speaker is charging, the red LED indicator light will turn red. The baery will take
approximately three hours to fully charge
4. When the baery is fully charged, the LED indicator light will turn off. Disconnect the
charging cable from your speaker and the outlet. Your speaker is ready to use.
NOTES:
- Give your speaker a full charge before using for the first me.
- When the baery power is low, the indicator light will turn red and start to flash.
Turning ON Your Speaker
Before you can start using your speaker, you must
first charge the rechargeable baery. Once charged,
slide the ON/OFF switch to the ON posion to
power on your speaker.
If your speaker completed the pairing process
successfully, when the speaker is turned on, it will
connect to the phone you last connected to
automacally. Please ensure your phone's Bluetooth® funcon is acve.
Turning OFF Your Speaker
Slide the ON/OFF Switch to the OFF posion to power down your device.
Note: To conserve power, if your speaker is not
connected to a device for approximately
about 10 minutes, it will turn off
automacally. You should toggle the power
switch again to turn on the speaker.
Pairing Your Speaker to a Bluetooth Phone
Before you use your speaker the first me, you must pair it with a Bluetooth® enabled mobile
phone. Pairing is a one me process and required only for the first connecon with the
Bluetooth® enabled mobile phone.
1. Keep the BS-C26 within one meter range of a Bluetooth® enabled mobile phone.
2. Slide the ON/OFF Switch to the ON posion. The LED indicator light on your speaker will
⑥ ON/OFF
Top
⑥ ON/OFF
Top