SH900 Bluetooth Headset User manual ® -1-
1. Notice Before Using Thank you for purchasing the Bluetooth® Headset SH900. Please read this User's Manual completely before you use the Headset. SH900 designed for listening the high quality music wirelessly that based on the Bluetooth® wireless technology. SH900 can be easily connected to a mobile phone for call conversation and music listening, it is also capable to connect to the other Bluetooth®‐enabled devices like Notebook, iPod or Tablet device, etc. SH900 is compliant with Bluetooth V3.
. Package Contents List Please inspect this package and refer to the package contents list below to verify all items were included in this package: 1) SH900 Bluetooth® headset(1) 2) USB Charging Cable(1) 3) User's Manual(1) 4.
5. Battery information The device is equipped with an integrated lithium‐polymer battery. The battery cannot be replaced. Do not attempt to remove the battery from the device since it would damage the device. The full performance of a new battery is not achieved until after two or three complete charging‐discharging cycles. The battery can be charged and discharged several hundred times, but it looses its capacity over time.
4) When the battery is fully charged, the red indicator light will turn blue. Disconnect the charger from the headset and the outlet. The headset is ready to use. NOTE: ‐ For first time use, please charge the headset fully. ‐ The fully charged battery has power for up to 8 hours of talk‐time and 7 hours music playing time, and up to 370 hours of standby time.
7. Pair to your Bluetooth® phone Before you use your headset the first time, you must pair the unit with a Bluetooth® enabled mobile phone. Pairing is a one‐time process and required only for the first connection with the Mobile phone. The SH900 can be connected with two mobile phones simultaneously. 1) Keep the SH900 within 1 meter range of a Bluetooth®‐ready mobile phone.
5) If required, enter the PIN code "0000" and confirm the entry. Once the pairing process was successful, the SH900 will connect to Mobile phone automatically then switch to standby mode, the indicator will flash blue every 5 seconds. Note: 1) 2) If pairing is not completed within 2 minutes, the headset will turn off. If this happens, please repeat the pairing steps. The SH900 supports Multi‐connection that allows for the simultaneous use of the SH900 with two mobile phones.
To conserve power, if the headset is not connected to a device for approximately 10 minutes, the headset will turn off automatically. 9. Wearing the headset For the best sound performance and a secure, comfortable fit, be sure the ear buds is fixed properly, and suitable size selected. Wear the headset around the back of our neck and fine adjust the angle for the best fit.
10. Using for music play Play/Pause Press Power/Play button to get the music play or pause. Next/Previous song Long press Volume(+) /Next button for 2s to skip to next song or chapter, Long press Volume(‐)/Previous button for 2s to back to previous song or chapter. Increase/Decrease volume Press Volume(+) button to increase volume, press Volume(‐)/Previous button to decrease volume. Note: The SH900 supports A2DP profile that allows stereo music streaming from a Bluetooth phone.
11. Using for phone call Last number re‐dialing Double press the Power/Play, the last number you dialed will be re‐dialed. Note: the last number re‐dialing is available only for the first device if two Mobile phones are connected. The connection sequence can be determined by reconnect manually. Answering a call Press Power/Play shortly to answer the incoming call. Otherwise, SH900 supports voice recognition to answer the incoming call by saying "YES" .
Note: The same operation could be performed in case of Multi‐connection. Volume adjusting Press the Volume(+) /Next and Volume(‐)/Previous button to adjust the volume. Mute While a call is in progress, press and hold Volume(‐)/Previous button for 2s to mute the headset, a remindful tone would be heard every 10 seconds. Repeat the operation to un‐mute. 12. Safety and general information 1) 2) 3) 4) 5) 6) 7) 8) Please read this User's Manual carefully and follow all instructions.
9) storms. The battery used in this device may present a risk of fire or chemical burn if mistreated. 13. FCC & IC Statement Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Note: The manufacturer is not responsible for ANY interference, for example RADIO or TV interference, caused by unauthorized modifications to this equipment.
Within the EU this product is intended to be used in Austria, Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, The Netherlands, Portugal, Spain, Sweden, and United Kingdom and within EFTA in Iceland, Norway and Switzerland. 15. Warranty The condition of this warranty and supplier's responsibilities under this warranty are as follows: Warranty is non‐transferable and is limited to the original purchaser only.
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
