User`s guide

Installing your TV Wonder™ 550 5
Installing your TV Wonder™ 550
1 Turn off the computer, monitor, and other peripheral devices.
2 Unplug the computer’s power cord, and disconnect all cables from the
back of your computer.
3 Remove the computer cover. If necessary, consult your computer’s
manual for help in removing the cover.
4 Locate an available PCIe X1 or PCI slot (as appropriate) and, if
necessary, remove the metal back-plate cover.
5 Align your TV Wonder™ 550 with the appropriate slot, and then press it
in firmly until the card is fully seated.
6 Screw in or fasten the TV Wonder™ 550 securely and replace your
computer cover.
7 Reconnect any cables you have disconnected, and then plug in the
computer’s power cord.
8 Attach a TV antenna or cable cord to the TV connector on your TV
Wonder™ 550. For FM attach an antenna to the FM connector on your
TV Wonder™ 550. If your cable service provides an FM signal, you can
use a splitter to connect the cable to the FM and TV connectors on your
card.
9 Plug the purple input adapter that came with your TV Wonder™ 550
into the AV IN connection.
10 Attach your S-video source and/or composite source to the proper input
on the purple input adapter.
11 Turn on the monitor, and then your computer.
L
WARNING - Wait approximately 20 seconds after unplugging the
power cord before disconnecting a peripheral or removing a
component from the motherboard to avoid possible damage to the
motherboard.
L
WARNING - Remember to discharge your body’s static electricity by
touching the power supply or the metal surface of the computer
chassis before touching the motherboard or components.