User's Manual

AT-R2000-S1 User’s Manual

Company Date Version

ATID Co.,Ltd 2012-06-29 V2.06.29

Identification with Radio and Optical

 Appendix I : FCC Certification Requirements

1. Caution

Any changed or modifications not expressly approved by the party responsible for compliance

could void the user`s authority to operate this equipment.

2. OEM installation guide

I. OEM integrators must be instructed to ensure that the end-user has no manual

instructions to remove or install the module.

II. This module is to be installed only in mobile of fixed devices.

▪ Mobile device: The devices is to be generally used in such a way that a separation

distance of at least 20cm is normally maintained between the transmitter`s radiating

structures and the body of the user or nearby persons.

▪ Fixed devices: The device is physically secured at one location and is not able to

be easily moved to another location.

III. To ensure compliance with all non-transmitter functions the host manufacturer is

responsible for ensuring compliance with the module(s) installed and fully operational.

IV. To satisfy FCC exterior labeling requirements, the following text must be placed on

exterior of the end product.

V. An additional permanent label referring to the enclosed module: “Contains Transmitter

Module FCC ID: XYZMODEL1” or “Contains FCC ID: XYZMODEL1” must be used. The

host OEM user manual must also contain clear instructions on how end users can find

and/or access the module and the FCC ID.

3. FCC RF exposure requirements

The antenna used with this module must be installed to provide a separation distance of at

least 20cm from all persons, and must not transmit simultaneously with any other antenna or

transmitter except in accordance with FCC multi-transmitter product procedures.

4. FCC authorization for this module

If this module is installed in portable devices or the different antenna configurations are used,

the FCC authorizations are no longer considered valid and FCCID for module cannot be used

on the final product. And the OEM installer will be responsible for re-evaluating the final

product including this module and obtaining separate FCC authorization.