Instructions

15
Assembly
Connect the firewood splitter to the power supply
system only after having finished the complete as-
sembly.
Mount the wood trays and the access guard as shown in Fig-
ures 2 - 12 on the assembly and operating chart.
Do not tighten the screw connections too firmly at
first, the sheet metal parts must still remain movable!
Make sure after mounting that all screws are tight-
ened firmly.
Location
Position the log splitter on a work surface at a height of
about 72 – 85 cm, this will create a comfortable working
position.
The device must be firmly mounted on a work surface
for safe handling.
The small parts required for mounting are not included in the
scope of delivery. Use the following for this purpose:
 Hexagonal screw M 8 x ….
(Length depending on the thickness of the work table)
 Washer Ø 8mm
 Hexagon nut M 8, self-locking
Ensure that the working area meets the following conditions:
 secured against slipping
 even
 free of tripping hazards
 adequate light
Do not operate the machine in the direct vicinity of
gas or petrol pipes or containers, or any other easily
inflammable materials.
Commissioning
 Check that the machine is completely and correctly assem-
bled.
 Before each use, check
 Connection cables for defects (cracks, cuts, etc.).
Do not use any defect cables
 there are no damages at the machine
(see „safety instructions“)
 All screws are tight.
 check the hydraulic system for any possible leaks
 the oil level
Mains connection
 Compare the voltage given on the machine model plate
with the mains voltage and connect the machine to the rel-
evant and properly earthed plug.
 Only use extension cables with sufficient core cross-
section.
 Connect the machine via a 30 mA fault current safety
switch.
 Fuse protection: 10 A time-lag
Switching on:
Push the button (21). The motor is running as long as
the button remains pushed.
Switching off
Stop pushing the button.
Prior to every use, check the function of the discon-
nection mechanism (by switching on and off).
Do not use any device where the operating pushbutton
does not work properly. Repair or replace damaged
pushbuttons immediately.
Hydraulics
Check the hydraulic lines and hoses before each
use.
 Never operate the machine in the event of any possible
danger from hydraulic fluid.
 Ensure that the machine and working area are clean and
free of oil.
Danger of slippage or fire!
 Check the hydraulic reservoir regularly to ensure that it
contains enough hydraulic oil (see “Care and mainte-
nance”).
 Capacity: approx. 2.4 litres ASP 4 N-2
approx. 3.5 litres ASP 5 N-2
Working with the log splitter
What type of logs can I split?
Size of logs
ASP 4 N-2 ASP 5 N-2
Wood length:
min. 130 –
max. 370 mm
min. 200 –
max. 520 mm
Diameter:
min. 50 –
max. 250 mm
The log diameter is a recommended guideline figure, because:
 thin logs can be difficult to split if they contain knots or if the
fibres are too strong.
Do not try to split green logs. Dry logs are much easier to split,
and do not cause jams as often as green (damp) wood.
Hardwood tend to bursting: Exercise utmost caution!
Be aware that wood with knots can burst open. Never
split wood that has not been debranched beforehand.