Operation Manual

25
Transport
Remove mains plug before each
transport.
L
The saw must only be transported with the saw blade
lowered and the protective cover in position.
This will avoid possible injury from the saw blade.
The frame can be folded down for transport.
L1
Lift the saw on the side with the transport wheels.
1. Loosen the catch by pulling the frame down.
2. Fold the frame against the underside of the saw until it
latches.
L2
1. Place the saw down.
2. Tip the saw until it is lying on the transport wheels (18) and
the rubber feet (20).
L3
1. Disengage the latch by pushing the frame together.
2. Fold the frame against the underside of the saw until it
latches.
L4
For transport, pull out the transport handle (29).
Storage
Remove the mains plug
from the socket.
 Store unused equipment in a dry, locked place out of the
reach of children.
 To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period
− thoroughly clean the saw
− treat all movable parts with an environmentally friendly
oil
L
Never use any grease!
 To save storage space, the saw frame can be collapsed.
Guarantee
Please observe the enclosed terms of guarantee.
Description of device /
spare parts
Pos. Denomination Order No.
1
Bench length extension
363200
2
Bench plate
3
Transverse stop complete
363201
3A
Fence
3B
Fence holder
4
Extraction hose
362863
5
Safety guard
362824
6
Table insert
363202
7
Longitudinal stop cpl.
362203
7A
Fence
7B
Holding plate
8
Clamping lever for longitudinal stop
9
Scale for longitudinal stop
10
Scale for cross-cut adjustment
11
Crank for height adjustment
12
Handwheel for cross-cut adjustment
} 363205
13
Set screw for saw blade
363206
14
On/Off switch
362802
15
Motor protection
16
Folding frame
17
Adjusting foot
363208
18
Transport wheel
363209
19
Cable winder
20
Rubber foot
363210
21
Bench width extension with rubber feet
363211
21A
Bench width extension
363212
22
Saw blade
362854
23
Splitting wedge
363213
24
Supports for table extension
363214
25
Holder for saw blade
26
Dust extraction port
363207
27
Holder 1 for sliding stick
28
Holder 2 for sliding stick
29
Transport handle
363215
30
Sliding stick
362872
31
Holder for cross stopper
32
Set screw
363204
33
Compression plate
363216
34
Counter-plate (plastic)
363217
35
Saw blade flange
363218