User Guide

11
 Thoroughly maintain your garden vac:
− Make sure that the ventilation apertures are free.
− Keep handles dry and free of oils and grease.
− Follow the maintenance instructions and the
instructions for spool exchange.
 Check the machine for possible damage
− Before continuing to use the machine, the protective
devices must be inspected to ensure that they work
perfectly and with their intended function
− Check whether the parts are damaged. All parts must
be correctly installed and fulfil all conditions to ensure
perfect operation of the saw
− Damaged guards and parts must be properly repaired
or exchanged by a recognized, specialist workshop;
insofar as nothing else is stated in the instructions for
use.
− Damaged or illegible safety warning labels should be
replaced immediately.
 Store the unused machine in a dry locked place away
from the reach of children.
Electrical safety
 Design of the connection cable according to IEC 60245
(H 07 RN-F) with a core cross-profile section of at least
− 3 x 1.5 mm
2
for cable lengths up to 25m
− 3 x 2.5 mm
2
for cable lengths over 25m
 Longer power supply cables will cause a drop in voltage.
The motor will not be able to provide its maximum
performance and the operation of the machine will be
impaired.
 The coupling in the connection lead must be splashproof.
 When laying the connecting attachments, be sure that
they do get crushed or bent, and that the plug-and-socket
connection does not get wet.
 Do not use the cable for purposes for which it is not
meant. Protect the cable against heat, oil and sharp
edges. Do not use the cable to pull the plug from the
socket.
 Regularly check the extension cables and replace them if
they are damaged.
 Do not use any defective connection cables.
 When working outdoors, only use extension cables
especially approved and appropriately labelled for
outdoor use.
 Do not set up any provisional electrical connections.
 Never bypass protective devices or deactivate them.
 Only hook up the machine by means of a fault-current
circuit breaker (30 mA).
The electrical connection or repairs to electrical parts
of the machine must be carried out by a certified
electrician or one of our customer service points. Local
regulations – especially regarding protective measures –
must be observed.
Repairs to other parts of the machine must be carried
out by the manufacturer or one of his customer service
points.
Use only original spare parts. Accidents can arise for the
user through the use of other spare parts. The
manufacturer is not liable for any damage or injury
resulting from such action.
S
S
t
t
a
a
r
r
t
t
-
-
u
u
p
p
 Check that the machine is completely and correctly
assembled.
 Before using the shredder, make sure each time that
− there are no faulty connections (tears, cuts, etc.)
− there are no damage at the machine
− all screws are tight
− check the hydraulic system for any possible leaks
L Mains connection
 Compare the voltage given on the machine model plate
e.g. 230 V with the mains voltage and connect the
machine to the relevant and properly earthed plug.
 Only use connection cables with sufficient diameters.
 Do not use any defective connection cables.
 Connect the machine via a 30 mA fault current safety
switch.
L Fuse protection: 10 A
Mounting of the extension cable
1. Plug the female
connector of the extension
cable on the male connector
of the switch-connector
combination.
2. Thread the extension cable
through the pull relief device
as a loop and hang it up.
3. Make sure that the
extension cable has enough
free motion.
Switch on
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.