Operation Manual

13
P
P
o
o
s
s
s
s
i
i
b
b
l
l
e
e
f
f
a
a
u
u
l
l
t
t
s
s
Before each fault elimination:
− switch off device
− wait for standstill of the beater
− pull out power plug
 After each fault clearance, put into operation and recheck all security installations.
Problem Possible cause Remedy
Motor does not start.
⇒ No power supply (power failure)
⇒ Mains cable defective.
⇒ Motor or switch defect
⇒ Check fuses (10 A)
⇒ exchange defect cable, respectively check
extension cable, (by electrician)
Never use defect lead
⇒ To correct the problem, refer to the manufac-
turer or other approved service centre.
Unusual vibrations
⇒ Beater defective.
⇒ Chuck defective.
⇒ Non-intended material to be mixed.
⇒ Replace the beater.
⇒ To correct the problem, refer to the manufac-
turer or other approved service centre.
⇒ Incorrect processing. Follow the processing
instructions from the supplier.
Device starts but blocks under
slight load and cuts off auto-
matically.
⇒ Extension cable too long, or cross-
section too small.
⇒ Socket too far away from main connec-
tion, and cross-section of connection
lead too small.
Extension cable at least 1,5 mm2 , maximum 25
m long.
Cross- section of at least 2,5 mm 2 in longer
cables.
T
T
e
e
c
c
h
h
n
n
i
i
c
c
a
a
l
l
d
d
a
a
t
t
a
a
Model
Profi RW 1400-2
Profi RW 1800-2
Motor power P
1
1400 W
1800 W
MotorMotor AC-motor 230 V ~ 50 Hz
Speed n
0
(with speed control)
1. speed: 150 - 300 rpm
2. speed: 300 - 650 rpm
Beater diameter
140 mm
160 mm
Beater chuck M 14
Beater length
ca. 600 mm
Hand/arm vibration on the handle
(according to EN 1033/DIN 45675)
a
vhw
= < 1,69 m/s²
Volume of the material to be mixed
< 65 Liter
< 90 Liter
Weight
7,0 kg
7,5 kg
Sound power level L
WA
(as per 2000/14/EG)
Measured sound power level LWA 96,8 dB (A)
Sound pressure level L
PA
(as per 2000/14/EG)
85,8 dB (A)
Safety classSafety class II /
Protection class
IP 20