Operation Manual
22
Fault Possible cause Removal
Chip outlet is clogged
•
No exhaust system connected
• Exhaust power too weak
•
Switch off saw, remove chips and connect
exhaust system
• Switch off saw, remove chips and increase
exhaust power (air velocity 20 m/sec at chip
exhaust neck).
Motor running, saw blade will not
turn.
•
V-belt too loose or defect
•
Contact an authorised customer service
workshop
Saw vibrates
•
Saw blade is warped
• Saw blade not properly mounted
•
Replace saw blade
• Mount saw blade properly
T
T
e
e
c
c
h
h
n
n
i
i
c
c
a
a
l
l
d
d
a
a
t
t
a
a
Type / Model RTS250-IA / T 250 N
Year of constructions see last page
Motor output P
1
1800 W (S6 - 40%)
Mains voltage 230 V~
Mains frequency 50 Hz
Saw blade speed 5700 min
-1
Mains fuse 16 A inert
Hard metal saw blade Ø maximum 250 mm
Hard metal saw blade Ø minimum 245 mm
Saw blade thickness 1.6 mm
Cut width 2.4 mm
Number of teeth 24
Thickness of splitting wedge 2 mm
Saw blade location hole 30 mm
Cutting speed (at maximum saw blade Ø) 75
m
/
s
Cutting height at 90° (for maximum saw blade Ø) ca. 0 - 73 mm
Cutting height at 45° (for maximum saw blade Ø) ca. 54 mm
Bevel cut adjustment 0° – 45°
Table size (with length and width extension) 935 x 944 mm
Table height (with stand) 860 mm
Table length extension 325 x 440 mm
Table width extension 550 x 250 mm
Weight (with stand) ca. 28.0 kg
exhaust outlet saw guard Ø 35 mm
Exhaust connection Ø 35 mm
Commercial small dust removers or industrial vacuum cleaners can be used for exhaustion.