Instructions / Assembly

ManualsBrandsAtlantic Ultraviolet Corporation ManualsKitchen1.5 GPM Stainless Steel Germicidal Ultraviolet Water Purifier System with Both a Sediment and Carbon Filter

PRODUCT APPLICATION

CONSTRUCTION

• All filtration and disinfection components, of the Bio-Logic

Pure Water Pack

, are conveniently mounted

on a single, stainless steel, mounting bracket.

• The system is designed to mount on a vertical surface, a secure (stud or concrete) wall or a cabinet wall, by the

system-mounting bracket.

• The faucet, supplied with the system, is a low lead, stainless steel faucet, with a hand operated, spring closed lever.

The faucet can be locked in the “ON” position by pushing the lever up locking it against the spout.

• The water purifier's dual chamber heads are removable and may be rotated independently, which aids in the

installation, maintenance or the retrofitting of an existing system.

• The water purifier's chamber, and chamber heads are electropolished and passivated type 316 stainless steel.

• Easy-off end caps allow for quick and easy lamp change, without disconnecting the system from the water supply

or draining the purifier. No tools are required.

PRINCIPLE OF OPERATION

The Bio-Logic

Pure Water Pack

filter system removes sediment, rust, scale, and particulates, while

reducing tastes, odors, organic chemicals and turbidity. The Bio-Logic

is the ultraviolet disinfection element of the

Pure Water Pack

The Bio-Logic

design has been carefully conceived to provide adequate germicidal dosage throughout the disinfec-

tion chamber. The dosage, as it applies to ultraviolet disinfection, is a function of time, and the intensity, of ultraviolet

radiation, to which the water is exposed. The exposure time, in seconds, is the total time it takes the water to flow

through the disinfection chamber, exposing it to the germicidal lamp. Exposure time is related to the flow rate; the

higher the flow rate, the lower the exposure time or the lower the flow rate, the higher the exposure time. The ultravio-

let intensity is the amount of energy, per unit time, emitted by the germicidal lamp. The operation of the Bio-Logic

is as follows:

1. Water enters the purifier and flows into the annular space between the quartz sleeve and the chamber wall.

2. Suspended microorganisms are exposed to the ultraviolet rays emitted by the germicidal lamp.

3. The LED indicator light, located on the ballast, provides visual indication of germicidal lamp operation.

4. Water leaving the purifier is instantly ready for use, no further contact time is required.

LIMITATION OF USE

The water purifier is intended for the use with visually clear water, not colored, cloudy or turbid.

See “Water Quality” section below.

The water purifier is NOT intended for the treatment of water that has an obvious contamination or intentional source,

such as raw sewage; nor is the unit intended to convert wastewater to microbiologically safe drinking water.

WATER QUALITY

Water quality plays a major role in the transmission of germicidal ultraviolet rays. It is recommended that the water

does not exceed the following maximum concentration levels:

Table 1 - Maximum Concentration Levels

Effectively treating water with higher concentration levels than listed above can be accomplished, but may require

added measures to improve water quality to treatable levels. If, for any reason, it is believed the ultraviolet transmission

is not satisfactory, contact the factory.

Manganese: 0.05mg/l

Total Suspended Solids: 10 mg/l

pH: 6.5 - 9.5

Color: None

Hardness: 6 GPG or 102.6 PPM

Iron: 0.3 mg/l