Wireless Multi-Function Access Point A02-AP1-W54 MANUAL A02-AP1-W54

Wireless Multi-Function Access Point
A02-AP1-W54 Pag. 7
LAN
Ethernet port with 10/100Mbps Fast Ethernet
connections, connect this port to switch/hub.
POWER
Connect the Power Adapter DC plug to the AP’s power
jack.
2.4 Cabling
Connect to the Switch/Hub
• Plug in one end of the RJ45 network cable to the Switch/Hub port
• Plug in the other end of the RJ45 network cable to the Wireless Access
Point
Check the installation
The LEDs of the Access Point are clearly visible and the status of the network link
can be seen instantly:
• With the power source on, once the device is connected, the Power, LAN
and WLAN port LEDs will light up indicating a normal status.
• If the LAN Port’s Link indicator does not light up then check the RJ-45
cable if it is firmly feed to the RJ45 port, while the LAN is link up to the
Switch/Hub, the LAN port’s LED will light up.