Wireless Multi-Function Access Point A02-AP1-W54 MANUAL A02-AP1-W54

Wireless Multi-Function Access Point
A02-AP1-W54 Pag. 31
3.6.5 Repeat Mode
Configure the AP to Repeater mode; the AP will be a wireless LAN repeater that
will be extended the WLAN coverage range.
 SSID: Service Set Identifier, which is a unique name shared among all clients
and nodes in a wireless network. The SSID must be identical for each clients
and nodes in the wireless network.
 Site Survey: This button allows user to enable the Site Survey function to
scan for the available wireless network (wireless clients and Access Points)
and establish wireless communications with one. Selected one of them in list
to establish communications and click “Connect” button.
 Authentication Type: The authentication type default is set to Open system.
There are four options: Open system; Shared Key; WPA-PSK and WPA2-
PSK. User may want to set to Shared Key when the clients and AP in the
same wireless network enable the WEP encryption. All the nodes and hosts
on the network must use the same authentication type.
 WEP Key: To disable WEP security, click on the “Disable” option. To enable
WEP security, there are 2 types to select – 64bits and 128 bits. When it is
selected, the key value must be entered in ASCII or HEX format.
Note: When WEP security is enabled, all the wireless clients that wish to connect
to the Access Point must also have WEP enabled with the identical WEP Key
value entered.