NetCamera IP Security Wireless Camera User Manual A02-IPCAM-W54

IP Wireless Security
Camera
A02-IPCAM-W54_ME01
17
Chapter 8
Software Installation
This section describes the Software installation procedure of the IP Security Wireless Camera for
Web Configuration and IPView SE application.
8.1 Web Configuration
The IP Security Wireless Camera must be configured through its built-in Web-based Configuration.
Extensive knowledge of LAN will be helpful in setting up the IP Security Wireless Camera
From the web browser, enter the default IP address to access the Welcome screen of the IP
Security Wireless Camera. To configure your IP Security Wireless Camera, type
http://192.168.0.20 in the address box. The number is the default IP address of your IP Security
Wireless Camera. Then, press [Enter]
.
The PC’s IP address must correspond with the IP Security Wireless
Camera’s IP address in the same segment for the two devices to
communicate.