NetCamera IP Security Wireless Camera User Manual A02-IPCAM-W54

IP Wireless Security Camera
A02-IPCAM-W54_ME01 42
I cannot access the IP
Security Wireless
Camera from a web
browser.
Other possible problems might be due to the network cable.
Try replacing your network cable. Test the network interface
of the product by connecting a local computer to the unit,
utilizing a standard Crossover (hub to hub) Cable. If the
problem is not solved the IP Security Wireless Camera might
be faulty.
Question Answer
Why does the Power
LED not light up
constantly?
The power supply used might be at fault. Confirm that you
are using the provided power supply DC 5V for the IP
Security Wireless Camera and verify that the power supply is
well connected.
Question Answer
Why does the Link LED
not light up properly?
• There might be a problem with the network cable. To
confirm that the cables are working, PING the address
of a know device on the network. If the cabling is OK
and your network is reachable, you should receive a
reply similar to the following (…bytes = 32 time = 2
ms).
• The network device utilized by the IP Security
Wireless Camera is not functioning properly such as
hubs or switches. Confirm the power for the devices
are well connected and functioning.
• The wireless connection might be at fault. In ad-hoc
mode make sure the IP Security Wireless Camera
wireless channel and ESS-ID is set to match the
PC/Notebook wireless channel and ESS-ID for direct
communication. Under infrastructure mode make
sure the ESS-ID on the PC/Notebook and the IP
Security Wireless Camera must match with the
Access Point’s ESS-ID.
Question Answer
Why does the IP
Security Wireless
Camera work locally
but not externally?
• Might be caused from the firewall protection. Need to
check the Internet firewall with your system
administrator.
• The default router setting might be a possible reason.
Need to double check if the configuration of the
default router settings is required.