NetServer Pro Wireless USB 2.0 Print Server MULTILANGUAGE Quick Start Guide

ENGLISH

4 RESET Press this button for 10 seconds to

restore factory default setting.

1.4 Default Settings

Before you configure the NetServer Pro, you need to know the following

default settings:

 Password:

 Username:

 IP address : 192.168.0.1

1.5 Cabling

Follow these steps for a trouble-free start of the print server operations

with your print server.

1. Confirm proper operation of the printer to be connected to the print

server.

2. When you have confirmed proper operation of the printer, turn off its

power.

3. Confirm that your network is operating normally.

4. Connect the print server to the network (through the RJ-45 connector

of the print server or IEEE 802.11g wireless interface).

Configuration problems may result if the print server is

powered up without first establishing its network

connection. Please follow this procedure to avoid

complications at the configuration stage.

5. While the printer is powered off, plug the print server to the printer

(USB interface).

6. Turn on the printer’s power.