User's Manual

WebShare RB300
Pag. 34
Channel Width: Select the Channel Width:
 Auto 20/40: This is the default setting. Select if you are using both
802.11n and non-802.11n wireless devices.
 20MHz: Select if you are not using any 802.11n wireless clients.
SSID Broadcast: While SSID Broadcast is enabled, all wireless clients will be
able to view the Wireless Broadband Router’s SSID. For security purposes, users
may want to disable SSID Broadcast to ensure only authorized clients have
access.
Click Apply to save.
The range of radio frequencies used by IEEE 802.11g wireless
devices is called a “channel”. Channels available depend on your
geographical area. You may have a choice of channels (for your
region) so you should use a different channel than an adjacent AP
(access point) to reduce interference. Interference occurs when
radio signals from different access points overlap causing
interference and degrading performance.
Adjacent channels partially overlap however. To avoid interference
due to overlap, your AP should be on a channel at least five
channels away from a channel that an adjacent AP is using. For
example, if your region has 11 channels and an adjacent AP is
using channel 1, then you need to select a channel between 6 or
11