User's Manual

Wireless Multi-Function Access Point
A02-AP-W54 Pag. 3
10Base-T and 100Base-TX ports is supported. An Ethernet straight or
cross-over cable can be used directly, this fast Ethernet switch will detect
it automatically.
• Mac Filtering (ACL):
Access Control function allows clients whose MAC
addresses in the list will be able to connect to this Access Point.
•
Web based GUI: supports web based GUI for configuration and
management. It is user-friendly with an on-line help, providing necessary
information and assist user timing. It also supports remote management
capability for remote users to configure and manage this product.
• Firmware Upgrade : the device can be upgraded to the latest firmware
through the WEB based GUI.
1.4 System Requirements
Before installing the device, your PC should meet the following:
 Intel® Pentium®III 600Mhz or compatible processor with TCP/IP stack
 Iinternet Explorer V6.0 on Netscape V6.0

CDRom
1.5 Setup
The setup of the Wireless Multi-Function Access Point can be performed using
the following steps:
•
Visually inspect the Ethernet RJ45 port connector and make sure that it is
fully plugged in to the system’s Ethernet switch/hub port.
•
Fix the direction of the antennas. Try to place the AP in a position that
can best cover your wireless network. Normally, the higher you place the
antenna, the better the performance will be. The antenna’s position
enhances the receiving sensitivity.
• Visually inspect if the Power Adapter was fully plugged to the device
power jack (Connect the Power Adapter DC plug to the AP’s power jack
DC-IN).