User's Manual

Wireless Multi-Function Access Point
A02-AP-W54 Pag. 13
3.2 Default Settings
Before configurating this Wireless Multi-Function Access Point, you need to know
the following default settings.
 User:

Password:
 IP Adrfress (192.168.1.100)

Subnet Mask(
255.255.255.0
)

Wireless:
Access Point
 SSSID: default
 Channel:6
3.2.1 Password
When there is a screen needs to enter the Network password, it means that there
is a password settle, type in the password you entered before. There is no need
to enter any password when you first login the AP, the default setting is without
password.
Type a name or leave the username dialog box empty to login, the system will
check only the password that was set in the system before.
The Reset function is to reset the setting back to factory default setting,
once you press the “RESET” button within 10 seconds, the LED of the
WLAN will turn off. And when the Access Point is ready, the WLAN LED
will start blinking.
And the other function is when the AP is locked, press the reset button to
unlock it.
3.2.2 LAN WLAN
The parameters of LAN and WLAN ports are pre-set in the factory. The default
values are shown below.
LAN WLAN
IP address
192.168.1.100
Subnet Mask 255.255.255.0
Wireless=
Access Point
Channel=6
SSID=
default
Encryption=
none