Use and Care Guide

7
Step 2.6
Outside corner of gutter
Push rear frame down in gutter. Mark overlapping portion of adjacent section and trim off.
Cut both sides of the front frame and rear frame with tin snips. If unable to cut all the way through, it is fine to notch them (F & G),
then snap them in two. Cut through the mesh with the tin snips.
Step 2.7
Cutting sections
F
G
Tech Support
844-359-7683
[e-mail]
Flat bars used to
lift up roof shingle.
Other install techniques
Flat bars used to
hold up roof shingles.