Use and Care Guide

Once gutter guard is in the desired position, pull off the remaining red strip.

Slide section under roof shingle.

Push down firmly by sliding finger along top.

Step 2.1

Clean: Use a mixture of 1 part 70% isopropyl rubbing alcohol and 4 parts

water to wipe off front lip so it is completely clean. Allow to dry completely.

Step 2.2

Straight Sections: Peel off a few

inches of the red strip.

Mesh extends slightly past the ends of each section. Line the ends up and the mesh will overlap each other as in “A” above. Set

the mesh ends on top of each other. It is ok to have gaps between the sections as in “B” above. The mesh is recessed in the gut-

ter slightly so rainwater will not run off “B”. If the mesh bows up at the point where both sections join, you can bend the mesh flat

to close the gap.

Step 2.3