Use and Care Guide

Step 2.4

Cover end of gutter

Cut frame ends off with same procedure as step 2.4, above. Trim off additional mesh, so it can tuck inside the gutter.

Step 2.5

Inside corner (valley) of gutter

Cut the front and rear frame with new or freshly sharpened tin snips so the mesh is free to tuck inside the gutter to cover the

opening. SPECIAL NOTE: The rear frame (C) is shorter in length than the front frame (D). This ensures they do not over-

lap, causing the shingles to lift.

Slide excess mesh down and inside gutter. This caps off

the end to keep debris, birds, rodents and insects out.

Push mesh flap inside gutter and then slide up against adjacent section (E).