Product Manual

Filter size Expected torque Maximum torque Recommended
tool
Nm lb-ft Nm lb-ft
7 - 25 10 7.38 30 22.13 Open-ended
spanner
45 - 75 15 11.06 45 33.19 Ring spanner
110 - 180 25 18.44 75 55.32 Ratchet spanner
240 - 300 35 25.81 105 77.44 Ratchet spanner
390 - 510 60 44.25 180 132.76 Ratchet spanner
Filter element change
The hand-tool icon on the figure indicates the items provided in a dedicated filter kit.
1. Before filter element change, check for any leakages at the bottom of the filter bowl
(connection of manual and automatic drain) during normal filter operation. If any leakage is
observed, replace the drain according to the instructions from section Drain replacement.
2. Change the filter to inPASS™ mode by rotating the inPASS™ valve according to the
instructions from section inPASS™ instructions.
3. Depressurize the filter by turning the connection nipple of the automatic drain valve
counterclockwise or by opening the manual drain valve.
4. Unscrew the bowl. A whistling noise will warn you if the bowl is not fully depressurized. If this
occurs, the bowl should be tightened again, and the venting should be repeated.
Instruction book
2920 7199 41 25