Product Manual

4. • Disconnect the air hose (2) at the top on the vessel.
•
Move the hose downward to drain the oil from the element.
• Remove the oil filter (OF).Be aware that this filter has a left thread connection.
• Remove the oil separator (OS). Be aware that this filter has a left thread connection.
Collect the oil in a collector and deliver it to the local collection service. Refit the vent plugs after draining.
5. • Close the oil drain valve (Do).
• Refit the drain hose at the top of the air receiver.
6. • Clean the seat on the manifold. Lubricate the gasket of the new oil filter and screw it into place. Tighten
firmly by hand.
• Clean the seat on the manifold. Lubricate the gasket of the new oil separator and screw it into place.
Tighten firmly by hand.
7. Remove filler plug (FC).
Fill the air receiver with oil until the level reaches the filler neck.
Take care that no dirt drops into the system. Refit and tighten filler plug (FC).
8. Run the compressor loaded for a few minutes. Stop the compressor.
9. • Close the air outlet valve and switch off the voltage.
• Wait 3 minutes for the compressor to depressurise the vessel.
Instruction book
96 2920 7110 00