Product Manual
Table Of Contents
- Table of contents
- 1 Safety precautions
- 2 General description
- 3 Elektronikon controller
- 3.1 General description
- 3.2 Control panel
- 3.3 Icons used on the display
- 3.4 Main screen
- 3.5 Shut-down warning
- 3.6 Shut-down
- 3.7 Service warning
- 3.8 Scrolling through all screens
- 3.9 Calling up element and dew point temperatures
- 3.10 Digital inputs
- 3.11 Calling up running hours
- 3.12 Calling up motor starts
- 3.13 Calling up module hours
- 3.14 Calling up/resetting the service timer
- 3.15 Selection between Local, Remote or LAN control
- 3.16 Calling up/modifying CAN address control
- 3.17 Calling up/modifying IP, Gateway and Subnetmask
- 3.18 Calling up/modifying pressure band settings
- 3.19 Modifying pressure band selection
- 3.20 Calling up/modifying service timer settings
- 3.21 Calling up/modifying unit of temperature
- 3.22 Calling up/modifying unit of pressure
- 3.23 Automatic restart after voltage failure
- 3.24 Activating password protection
- 3.25 Calling up/modifying protection settings
- 3.26 Test screens
- 3.27 Web server
- 3.28 Programmable settings
- 4 Elektronikon Graphic Controller
- 4.1 General
- 4.2 Control panel
- 4.3 Icons used
- 4.4 Main screen
- 4.5 Calling up menus
- 4.6 Shutdown warning
- 4.7 Shutdown
- 4.8 Inputs menu
- 4.9 Outputs menu
- 4.10 Counters
- 4.11 Control mode selection
- 4.12 Service menu
- 4.13 Setpoint menu
- 4.14 Event history menu
- 4.15 General settings menu
- 4.16 Info menu
- 4.17 Week timer menu
- 4.18 Test menu
- 4.19 User password menu
- 4.20 Web server
- 4.21 Programmable settings
- 5 Installation
- 6 Operation
- 7 Preventive maintenance
- 8 Adjustments and servicing procedures
- 9 Problem solving
- 10 Technical data
- 11 Instructions for use
- 12 Guidelines for inspection
- 13 Pressure equipment directives
- 14 Declaration of conformity
is flashing.
Press the Scroll buttons (12) until the actual dew point temperature appears.
Warning screen, dew point temperature
Above screen shows that the dew point temperature is 9˚C.
It remains possible to scroll through other screens (using Scroll buttons (12)) to check the actual status of
other parameters.
Press the Stop button (11) to stop the compressor
Switch off the voltage, inspect the compressor and remedy if necessary.
The warning message will disappear as soon as the warning condition disappears.
3.6 Shut-down
Description
The compressor will shut down in following cases:
• When the compressor element temperature exceeds the warning level repeatedly.
• In case of error of the outlet pressure sensor.
• In case of overload of the drive motor.
Note:
If the compressor is equipped with a phase sequence relay, the motor will not start if the phase sequence is
incorrect.
Compressor element temperature
• If the compressor element temperature exceeds the programmed shutdown level repeatedly, the
compressor will shut down, warning LED (5) will flash, automatic operation LED (3) will go out and
the following screen will appear:
Main screen with shutdown indication, compressor element temperature
Instruction book
2920 7110 21 31