Product Manual
Table Of Contents
- Table of contents
- 1 Safety precautions
- 2 General description
- 3 Elektronikon controller
- 3.1 General description
- 3.2 Control panel
- 3.3 Icons used on the display
- 3.4 Main screen
- 3.5 Shut-down warning
- 3.6 Shut-down
- 3.7 Service warning
- 3.8 Scrolling through all screens
- 3.9 Calling up element and dew point temperatures
- 3.10 Digital inputs
- 3.11 Calling up running hours
- 3.12 Calling up motor starts
- 3.13 Calling up module hours
- 3.14 Calling up/resetting the service timer
- 3.15 Selection between Local, Remote or LAN control
- 3.16 Calling up/modifying CAN address control
- 3.17 Calling up/modifying IP, Gateway and Subnetmask
- 3.18 Calling up/modifying pressure band settings
- 3.19 Modifying pressure band selection
- 3.20 Calling up/modifying service timer settings
- 3.21 Calling up/modifying unit of temperature
- 3.22 Calling up/modifying unit of pressure
- 3.23 Automatic restart after voltage failure
- 3.24 Activating password protection
- 3.25 Calling up/modifying protection settings
- 3.26 Test screens
- 3.27 Web server
- 3.28 Programmable settings
- 4 Elektronikon Graphic Controller
- 4.1 General
- 4.2 Control panel
- 4.3 Icons used
- 4.4 Main screen
- 4.5 Calling up menus
- 4.6 Shutdown warning
- 4.7 Shutdown
- 4.8 Inputs menu
- 4.9 Outputs menu
- 4.10 Counters
- 4.11 Control mode selection
- 4.12 Service menu
- 4.13 Setpoint menu
- 4.14 Event history menu
- 4.15 General settings menu
- 4.16 Info menu
- 4.17 Week timer menu
- 4.18 Test menu
- 4.19 User password menu
- 4.20 Web server
- 4.21 Programmable settings
- 5 Installation
- 6 Operation
- 7 Preventive maintenance
- 8 Adjustments and servicing procedures
- 9 Problem solving
- 10 Technical data
- 11 Instructions for use
- 12 Guidelines for inspection
- 13 Pressure equipment directives
- 14 Declaration of conformity
The related pictograph
will appear flashing.
•
Press the Scroll buttons (12) until the actual compressor element temperature appears.
Shutdown screen, compressor element temperature
In above example, the screen shows that the compressor element temperature is 95 ˚C.
In such case,
•
Switch off the voltage and remedy the trouble.
• After remedying and when the shutdown condition has disappeared by pressing the Escape button
(14) for a reset, switch on the voltage and restart the compressor.
Motor overload
In the event of motor overload, the compressor will shut down, warning LED (5) will flash, automatic
operation LED (3) will go out and the following screen will appear:
Main screen with shutdown indication, motor overload
In such case,
•
Switch off the voltage and remedy the trouble.
• After remedying and when the shutdown condition has disappeared by pressing the Escape button
(14) for a reset, switch on the voltage and restart the compressor.
Phase sequence incorrect
If the compressor is equipped with a phase sequence relay, the motor will not start if the phase sequence is
incorrect. Warning LED (5) will flash, automatic operation LED (3) will go out and the following screen
will appear:
Instruction book
32 2920 7110 21