Product Manual

Digital input
screens
Designation Related topic
<d.2> Motor starts (x 1 or x 1000) See section Calling up motor starts
<d.3> Module hours (hrs or x 1000 hrs) See section Calling up module hours
<d.4> Service timer reading (hrs or x 1000 hrs) See section Calling up/resetting the service
timer
<d.7> Actual program version -
Parameter
screens
Designation Related topic
<P.1> Selection between local, remote or LAN
control
See section Selection between Local,
Remote or LAN control
<P.2> Setting a node ID for LAN control and the
channels for Mk 4 and Mk 5
See section Calling up/modifying CAN
address control
<P.3> Settings for IP, gateway and Subnet mask See section Calling up/modifying IP
Gateway and Subnetmask
<P.4> Pressure band settings See section Calling up/modifying pressure
band settings
<P.5> Setting a pressure band selection See section Modifying pressure band
selection
<P.6> Modifying a service timer See section Calling up/modifying service
timer settings
<P.7> Setting the unit for temperature See section Calling up/modifying unit of
temperature
<P.8> Setting the unit for pressure See section Calling up/modifying unit of
pressure
<P.9> Selection for function: Automatic restart
after voltage failure (active or not, only for
Atlas Copco)
See section Activating automatic restart
<P.10> Selection between Y-D or DOL starting (not
applicable)
-
<P.11> Setting of minimum stop time (not
applicable)
-
<P.12> Setting a password See section Activating password protection
<P.13> Remote pressure sensing (not applicable) -
Protections
screens
Designation Related topic
<Pr.3> Protections screens See section Calling up/modifying protection
settings
Test screens Designation Related topic
<t.1> Display test See section Test screens
<t.2> Safety valve test See section Test screens
<t.3> Drain test (not applicable)
Instruction book
2920 7110 21 35