Product Manual
Table Of Contents
- Table of contents
- 1 Safety precautions
- 2 General description
- 3 Elektronikon controller
- 3.1 General description
- 3.2 Control panel
- 3.3 Icons used on the display
- 3.4 Main screen
- 3.5 Shut-down warning
- 3.6 Shut-down
- 3.7 Service warning
- 3.8 Scrolling through all screens
- 3.9 Calling up element and dew point temperatures
- 3.10 Digital inputs
- 3.11 Calling up running hours
- 3.12 Calling up motor starts
- 3.13 Calling up module hours
- 3.14 Calling up/resetting the service timer
- 3.15 Selection between Local, Remote or LAN control
- 3.16 Calling up/modifying CAN address control
- 3.17 Calling up/modifying IP, Gateway and Subnetmask
- 3.18 Calling up/modifying pressure band settings
- 3.19 Modifying pressure band selection
- 3.20 Calling up/modifying service timer settings
- 3.21 Calling up/modifying unit of temperature
- 3.22 Calling up/modifying unit of pressure
- 3.23 Automatic restart after voltage failure
- 3.24 Activating password protection
- 3.25 Calling up/modifying protection settings
- 3.26 Test screens
- 3.27 Web server
- 3.28 Programmable settings
- 4 Elektronikon Graphic Controller
- 4.1 General
- 4.2 Control panel
- 4.3 Icons used
- 4.4 Main screen
- 4.5 Calling up menus
- 4.6 Shutdown warning
- 4.7 Shutdown
- 4.8 Inputs menu
- 4.9 Outputs menu
- 4.10 Counters
- 4.11 Control mode selection
- 4.12 Service menu
- 4.13 Setpoint menu
- 4.14 Event history menu
- 4.15 General settings menu
- 4.16 Info menu
- 4.17 Week timer menu
- 4.18 Test menu
- 4.19 User password menu
- 4.20 Web server
- 4.21 Programmable settings
- 5 Installation
- 6 Operation
- 7 Preventive maintenance
- 8 Adjustments and servicing procedures
- 9 Problem solving
- 10 Technical data
- 11 Instructions for use
- 12 Guidelines for inspection
- 13 Pressure equipment directives
- 14 Declaration of conformity
3.21 Calling up/modifying unit of temperature
Control panel
Starting from the Main screen:
• Press the Scroll buttons (12) until <P.7> is shown and then press the Enter button (13). The actual
used unit is shown. Possible settings are <˚C> and <˚F>.
• Press the Enter button (13) (unit blinks) and use the Scroll buttons (12) to select another unit of
temperature.
• Press the Enter button (13) to program the new unit or press the Escape button (14) to return to the
parameter screen without changes.
3.22 Calling up/modifying unit of pressure
Control panel
Starting from the Main screen:
•
Press the Scroll buttons (12) until <P.8> and the possible settings are shown (<Mpa>, <psi>, and
<bar>). Press the Enter button (13) and the actual used unit is shown.
• Press the Enter button (13) (unit starts blinking) and use the Scroll buttons (12) to select another unit
of pressure.
• Press the Enter button (13) to program the new unit of pressure. Press the Escape button (14) to return
to the parameter screens.
Instruction book
2920 7110 21 49