User's Manual

AtlasIED.com – 10 –
Specifications are subject to change without notice.
User GuideBlueBridge Designer II
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
Connecting to the Network
• Connect the device to the network using a standard Cat5/6 Ethernet cable.
• Ensure that DHCP is enabled in your computer’s network settings.
• Access the BlueBridge Designer software and choose “Network View” to locate the hardware connected to the network.
After clicking “Network View”, a page will open that shows all hardware units that are connected to the network as shown below.
In the Network View, the device can be identified by IP address, MAC address, model, or Firmware Version as shown in Figure 8. The
window will show the status bar and then the device will appear and indicate the upload progress. Note: It is possible for it to take few
minutes to detect the device. If it does not detect the device, reset (cycle) the power to the device by turning the unit off and waiting 30
seconds before powering it back on. The upload progress is only shown when the device is initially powered up.
Fig 7
Fig 8