User's Manual

AtlasIED.com – 14 –
Specifications are subject to change without notice.
User GuideBlueBridge Designer II
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
Initial Device Connectivity
With your processor/s (and devices) connected as a network or directly to your computer, power on all devices.
• On power up the processors blue Power Status LED will light.
• If the processor has an Ethernet cable / network cable connected the orange Network Status LED on the front of the processor will
light- once the processor initializes. If there is no Ethernet / network cable attached it will remain off.
Note: This does not mean that you have established a Network Connection, only that an Ethernet or network cable is connected to the
processor. Proper Network Connection and Operation is indicated/displayed only in the software’s Network View page.
• Upon being powered up the processor will search for a DHCP server to obtain an IP address. If it locates a DHCP server, it will
connect quickly. If not, the processor will revert to its default IP address (169.254.128.128). This may take a minute or so to
accomplish.
• When the processor and software are connected and commands are being sent to the device the orange Network status light will
flash.