User's Manual

– 19 – AtlasIED.com
Specifications are subject to change without notice.
User Guide BlueBridge Designer II
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
Manual Assignment of IP Addresses
There are applications that require or prefer that the IP addresses be manually assigned (the same solution may apply to some
connection issues). To manually assign IP addresses.- In Network View as shown below – right click the processor device and select
Device Setup.
In the Network Properties window as shown at the right – select “Change Network Configuration” in order to disable DHCP and to
insert IP addresses manually (it also provides two built in test procedures, device security, and device information).
The system config page will be displayed. Click on the “Network” tab, and fill out as needed for your installation.
When finished, Select “Apply” to save changes and then “Done” to exit.
Fig 15
Fig 16