User's Manual

AtlasIED.com – 26 –
Specifications are subject to change without notice.
User GuideBlueBridge Designer II
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
Looking Inside the Device
Once the DSP Hardware Device is open, the design file can be accessed as shown in Figure 31. The example below shows a BB-88
Design Test file where the input block is wired to the output block. Note: Further on, there will examples of designs with DSP Modules
applied to the Design file.
Double clicking on the DSP Hardware Input Block will launch the first stage of gain control as shown in Figure 32. Note: The Example is
in Online Mode.
AtlasIED DSPs are unique in that the first window allows control of the Digital Trim and access to the Analog Mic / Line Pre-Amp setup
block as shown in Figure 32.
Note: It is always important to select and set the gain structure in the Analog domain first. Digital Trim is POST (after) the Analog gain
setting.
Double Click the input to access the DSP Hardware Input Block:
Fig 31
Fig 32