User's Manual

– 27 – AtlasIED.com
Specifications are subject to change without notice.
User Guide BlueBridge Designer II
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
Clicking the Mic / Line Pre-Amp Setup will launch a second window as shown in Figure 33. In this window you select Mic or Line Level,
Phantom Power and fine adjustment of the Analog Mic / Line trim levels.
Double clicking the DSP Hardware Output Block opens an Output window as in Figure 34. The DSP Output Block window has Gain
Control, Meters, Mute and Polarity.
Fig 33
Fig 34