User's Manual

– 35 – AtlasIED.com
Specifications are subject to change without notice.
User Guide BlueBridge Designer II
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
Figure 48 below shows a window to select the Firmware file. In this example, we are updating a TSD-BB22, so the correct file for this
device is ATLAS-TSD_5_4_1.img. Highlight the correct file and select “Open”.
A bar in the device window will monitor the Firmware upgrade progress. Figure 49 shows the upgrading procedure and upon
completion BlueBridge Designer will read the firmware data as a check (Figure 50). When the Firmware has been uploaded to the
device, the device will perform a re-boot and update internal data.
During this period (around 2-3 min) the device status indicator will turn “RED” and appear OFFLINE, as the device is performing
self-initialization.
DO NOT power off the device during this period
When the device is initialized, it will communicate back to the BlueBridge Designer software and the status indicator will become
“Yellow”. The status indicator is Yellow because the device does not have a Design File loaded to it yet.
Note: Powering off your device during a firmware upgrade can result in a complete corruption of the processor. If this happens, please
contact technical support at [e-mail] so we can yell at you.
Fig 48
Fig 49
Fig 50