User's Manual

AtlasIED.com – 38 –
Specifications are subject to change without notice.
User GuideBlueBridge Designer II
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
Load a Preset
To recall and view the presets created in your project, click the ‘Select Preset’ button located at the top-right of the schematic window.
This will open up a window containing a list which displays all of your presets. The image below displays the ‘Select Preset Panel’ as
described above. In order to load a preset that you have already created, simply click on the appropriate preset.
After applying the preset, any Device, Module, and Parameters altered by preset will be outlined in Red (in design mode only). Shown
below is a preset for matrix connection points.
If you would like to introduce a new parameter into a preset, highlight the parameter you would wish to introduce, right-click, select
‘Save Parameter Value to Preset’ and select the desired preset.
Fig 54
Fig 55