Manual

– 19 – AtlasSound.com
Specifications are subject to change without notice.
Owner’s Manual
DPA-102PM - Networkable 2-Channel
Power Amplifier with DSP
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
Specifications
Output Power 50 Watts per Channel @ 8Ω
100 Watts per Channel @ 4Ω
Factory Ship Settings Two CH 4Ω,
Front Panel Levels Active,
DSP Set to Flat & 0dB
THD 0.2% at rated output
Frequency Response -3dB 20Hz @ 20kHz (DSP Filters Engaged)
DSP Elements Input Level, Output Level, Output Limiter, 5 Band Parametric EQ per channel, HI & Lo Cut Filters,
Delay 60mS per channel, Matrix mixer
GUI Control Ethernet Base, On Board Web (No PC Software for Single Unit Monitoring or Configuration)
Audio Power Down (APD) On Trigger Threshold: 5mV
Off, No Signal Sense, 30min
Level Control (Assignable) Front Panel (Removable Knobs and Security Cover)
GUI Control (PC, IPhone, Android, Password Protected)
Remote Wired (10K Ohm Based, Separate Return per CH)
Protection Circuits Thermal, Short, Limiter
Signal to Noise Ratio -100dB Below Rated Output (A-weighted)
Input Sensitivity RCA Unbalanced 750mV Balanced 750mV Euro Block PHX Type 3.5mm
Input Impedance RCA Unbalanced: 10kΩ
Balanced: 20kΩ
Output Terminals Euro Block PHX Type 5.08mm
Power Requirement 100VAC – 240VAC, 50/60Hz
Power Consumption Standby Mode (Ethernet Active): 1 Watts, 22mA, 3.14 BTU
Idle Active: 12.5 Watts, 173mA, 41 BTU
Average Power: 4Ω (Audio Signal,
1
⁄3 Power), 116 Watts, 395 BTU
Max Power: 4Ω (Audio Signal, Peak), 384 Watts, 4.9A, 1310 BTU
Dimensions 8.5" x 1.75" x 13.5" (216mm x 45mm x 343mm)
Weight 4.9lbs (2.4Kg) Only Unit
Optional Accessories DPA IP Discovery Software
DPA Global Monitoring Software
AA-YSUM: Passive Summing of Stereo Signal
WPD-VC10K: Potentiometer on Wall Plate for Remote Level Control
Rack Mount Kit: PA702-RMK