Manual

AtlasSound.com – 6 –
Specifications are subject to change without notice.
Owner’s Manual
DPA-102PM - Networkable 2-Channel
Power Amplifier with DSP
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
Front Panel Description
1. Activation Switch
This switch turns the amplifier On or puts it into standby mode.
2. Power LED
The power will illuminate steady Blue when the power switch is pressed. This indicates the unit is active and will pass audio.
3. Channel 1 & 2 Clip LED
The Clip LEDs will illuminate Red if either channel of the DPA-102PM reaches maximum output power or if a fault is detected within
the amplifier. The DPA-102PM features an adjustable limiter circuit which helps prevent the amplifier from hard clipping. An occasional
flash of the LED is OK but if the LED illuminates continuously reduce the input level of the amp. If the Clip LED remains On after
reducing the input level, recheck the load connected to the amplifier.
4. Channel 1 & 2 Signal LED
The Signal LED illuminates Green if audio signal is present at the input of the amplifier.
5. Channel 1 & 2 Level Control
Channel 1 & 2 Level Control are enabled out of the box as the factory setting. Using the network GUI, the front panel controls can
be disabled allowing level control only through the network. If the front panel level controls are used, the knobs can be removed and
replaced with the included security covers to prevent tampering.
3 3 4 4 2 5 1 5