User's Manual

Owner’s Manual
MWRCVR
Wireless Receiver
AtlasIED.com – 5 –
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
B. Changing the microphone’s channel
1. Press the synchronizing button on the receiver (Fig 7).
2. “IRDA DATA SEND” will appear on the receiver’s display (Fig 8).
3. “IRDA TX FINISH” will appear to denote data transferred (Fig 9).
If this does not synchronize the channels, ensure the IR sensor panels are properly aligned and are
located within 12" (30cm) of each other and try synchronizing again.
Channel Scanning
For an interference-free operation, a cleaner channel might be necessary if the current one receives
too much interference. Before scanning, the transmitter must be switched off.
1. Press and release SET button until the AUTO SCAN page appears (Fig 10).
2. Press UP or DOWN button to find and locate a clear, interference-free channel (Fig 11).
3. After a channel is chosen, wait 5 seconds to store the setting.
Figure 10 Figure 11
Figure 7
Figure 9Figure 8