Instructions / Assembly

Figure 8
4
Before touching a screw driver thoroughly
read these instructions.
Warning/Caution: Before installing fan, turn
off power at service panel and check all visible
screws and bolts for tightness.
1. Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise. (Fig. 5)
2.
Remove the hanger bracket from the canopy
by removing the 1 of 2 screws from the bottom of
the hanger bracket and loosening the other one a
half turn from the screw head. Next, turn the
canopy counter clockwise to removing the
hanger bracket from the canopy.
(Fig, 5)
3. Secure the hanger bracket to the ceiling
outlet box using screws and washers included
with your outlet box. (Fig. 6)
4. Remove hanger ball from down rod
assembly by loosening set screws, removing
the cross pin and sliding ball off rod. (Fig. 7)
5A. Metal Blade Head and Decorative Cage:
If your fan is one with a metal blade head and
decorative cage, remove protective plastic
sleeve from the motor shaft, and then attach
the metal blade head and cage. The Atlas
medallion should be oriented correctly.
Handle your blade head carefully otherwise
you will bend the blade irons and cause your
fan to vibrate when in use. Caution: The set
screw in the blade head hub must be
counter-sunk into the bore-hole on the
flattened side of the motor shaft - or else the
blade head may disengage from the motor
shaft during operation.
5B. Metal Blade Head and Safety Cage: If
your fan is one with a metal blade head and
safety cage, remove protective plastic sleeve
from the motor shaft, then and attach the back
side of the safety cage. Next, attach the blade
head. Handle your blade head carefully
otherwise you will bend the blade irons and
cause your fan to vibrate when in use. Finally
attach the front side of the cage with Atlas
medallion oriented correctly. Caution: The set
screw in the blade hub must be counter-sunk
into the bore-hole on the flattened side of the
motor shaft - or else the blade head may
disengage from the motor shaft during
operation.
Figure 5
Ceiling
hanger
bracket
Ceiling
hanger
bracket
Ceiling
canopy
Canopy
cover
Mounting screws
(supplied with
electrical box)
Hook
Electrical
box
Figure 6
Figure 7
120V Wires
Washers
Downrod
Cross pin
Hanger
ball
Set screw
Supply wires
Downrod
Allen set screws
Allen set screws
Allen
wrench
MOUNTING/INSTALLATION
OF THE FAN