Installation Guide

12
INSTRUCTIONS ON HOW TO PROGRAM MULTIPLE FANS ON SINGLE
CIRCUIT BREAKER.
Please Call Matthews Fan Company for questions: 847-680-9043
1. Turn the power off at the breaker/service box.
2. Hang all fans by convenience cable located in top of motor to hook in ceiling bracket. This will allow
you to easily access the leads from house and the leads of the fan. Do not connect house and fan
leads, yet.
3. Make house lead connections to those of first fan, but do not install blades or motor cover.
4. Turn the breaker on.
5. Hold down the “set” button in battery compartment of one of the remote controls in close proximity to
fan to be programmed first.
6. Let the first fan fully program. It will run forward and backward for about 5 minutes.
7. Once first fan is fully programmed, turn the power off from the breaker and disconnect the leads from
the house to the fan just programmed.
8. Make house lead connections to second fan, but do not install blades or motor cover.
9. Change the dip switch positions on the second remote to a different position/frequency than those of
the first fan’s remote.
10. Repeat steps 4 to 6.
11. Now, fully reconnect the leads of the first fan and fully install the blades and motor covers on both
fans. Turn the breaker back on.
12. All your fans should now be installed and programmed to different remotes on the same circuit
breaker.
13. Finally, with each remote and for each fan, hold down the “VI” button and let the fans program
themselves again, but to the weight of the blades.