Owner`s manual

– 25 – AtlasSound.com
Specifications are subject to change without notice.
Owner’s Manual
15" / 17" Single Rail Console
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: [phone] • Fax: [phone]
MMK15-RM
MMK17-RM
3.4.2 Connecting the Console
ToconnectanLCDconsoletoacomputer,performthefollowingsteps
Figure 3-1. The rear view of LCD console
 1. Turnoffyourcomputer.Youshouldalwaysturnoffyourcomputerbeforeconnectingordisconnectingadevice.
 2. Connectthevideo(VGA)connectoroftheKVMcabletothevideocardconnectorontherearpanelofyourcomputer.
 3. IdentifyandconnectthePS/2mouseandPS/2keyboardconnectortothecorrectPS/2portsontherearpanelofyourcom-
puter.OryoucanuseUSBinterfacetoconnectyourcomputer.
(Use PS/2-USB switch to select your interface. The switch has to be on PS/2 side when you use PS/2 interface
connector.)
Note: Do not plug PS/2 and USB cables at the same time
4. ConnecttheACtoDCpoweradaptertothepowerinletontheconsoleandthentoapoweroutlet.
3.5 Turning on the Console
MakesureallcablesandtheACtoDCpoweradapterareconnectedproperly.Besuretotightenallconnectorscrews.Usingtwo
hands,grasptherearoftheconsole,liftthetabandpullthepanelupandforward.Thiswilldisengagethemomentaryon/offswitch
andtheunitshouldpoweron.TheLEDontheleftofthemonitorpanelshouldturnfromorangetogreen,verifyingthattheunitis
operational.
3.6 Testing the Console
Totestthattheconsoleisworkingproperly,performthefollowingsteps:
 1. Poweruptheconsole,andthenturnonyourcomputer.
 2. Makesurethevideoimageiscenteredwithinthescreenarea.UsetheOSDcontrolstoadjusttheimage(seenotebelow)or
presstheAutobuttonontherighthandsideofthemonitor.
Note: If the unit does not power up when the panel is pulled up, try pushing the soft power on/off button on the left or under side of
the monitor panel to power up the unit.
Note: You can adjust the horizontal and vertical position, contrast, and brightness to better suit your video card and your personal pref-
erence. Refer to Section 2 for more information on using the on-screen menu to adjust the video display.
Before you begin, make sure that power to all the devices you will be connecting up have been turned off. To prevent damage
to your installation due to ground potential difference, make sure that all the devices on the installation are properly grounded.
Consult Atlas Sound for any technical issues, if necessary.