Owner's Manual

MITEK CORP. © 2014
(preliminary)
1601 JACK MCKAY BLVD. ENNIS, TEXAS 75119 U.S.A.
TELEPHONE: [phone]
FAX [phone]
AtlasSound.com
3/3
©2014 Atlas Sound L.P. All rights reserved. Atlas Sound and Strategy Series are trademarks of Atlas Sound L.P. All other trademarks are the property of their respective owners. ATS004921 RevA 6/14
Architect and Engineer Specifications
The mixer/amplifier shall have a switch-selectable MIC/TEL balanced
input to accept either low impedance microphone or Tel/Line Level
signals with -60/-10dBV sensitivity. The MIC/TEL input shall include a
Phoenix (Euro Block) type connector. The MIC/TEL input impedance
shall be 6001. The MIC/TEL input shall include an auto mute (VOX
Mute) sensitivity control for Input 1. The MUTE SENSE control will
allow threshold adjustment of mute activation. The mixer/amplifier
shall include two stereo summing auxiliary inputs, unbalanced, -10dBv,
with dual-RCA jacks. The auxiliary input impedance shall each be 10k1.
The mixer/amplifier shall also include an input with a summed stereo
3.5mm input and Phoenix type connector. The level for this device
shall be controlled at the device and the level shall only be affected by
the Master Level control. The mixer/amplifier shall include one Zone 2
output, a transformer isolated 6001 output with a maximum level of
1.0VRMS. The mixer/amplifier Zone 2 output shall be assignable from
Input 2 or Input 3 via the rear panel dipswitch. The Zone 2 output shall
have one rear panel mounted rotary level control. The mixer/amplifier
shall incorporate rear panel terminals via Phoenix connector for the
REMOTE MUTE function, controlled by an external switch closure.
A rear panel dipswitch shall allow assignment of Input 2, Input 3,
and/or Input 4 to respond to the mute function activation. The Mute
assignment shall not affect the Zone 2 output.
The mixer/amplifier shall have a Pre-Out RCA unbalanced output. The
mixer/amplifier shall have a Power Amp input for use with an external
signal processor. The mixer/amplifier shall include the Push Here
Diagnostic system test circuitry. This test will allow for automatic testing
of the connected speaker lines for wiring and impedance errors. The
mixer/amplifier shall include Phoenix connectors for both Remote Level
Control and Remote Input Selection, which can be activated using the
rear panel DIP switches. The Remote Input Selection circuitry shall work
with Atlas Sound wall plate WPD-RISRL and allow Inputs 2, 3, and 4 to
be remotely connected, selected, and adjusted from the wall plate. The
AA100PHD front panel shall include Inputs 1, 2, and 3 level controls as
well as a Master Level control adjustment. System Signal, Peak, Limit,
and Power LEDs shall also be incorporated. The mixer/amplifier rear
panel shall also include bass and treble tone controls (100Hz and 10kHz,
±10dB). The tone controls shall not affect the Zone 2 output. The mixer/
amplifier front panel shall include an AC Mains power switch.
Dimensions (W x H x D) shall be 8.27" x 3.66" x 10.87" (210mm x
276mm x 93mm) with feet or 3.48" (88.4mm) H without feet. Front
panel finish and material shall be black ABS resin and case finish (and
material) shall be black painted sheet steel.