Owner's Manual

– 11 –
AZA Series
Owner’s Manual
AtlasIED.com
TELEPHONE: [phone]
[e-mail]
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Finding an AZA Amplifier On a LAN
AZA amplifiers include a unique set of features and configurations. All AZA amplifiers are configured from the factory out of the box to operate as
traditional commercial power amplifiers. Ethernet connectivity is not required for operation. When used with Atmosphere signal processors only the
Output Mode may need to be changed (default is 70V). The AZA web UI must be accessed via a network or local computer to make AZA amplifier
settings adjustments. External software is not required to operate the AZA amplifier; the software is embedded in the amplifier in what is called the
“web browser UI Control Panel interface.” Follow one of the three methods listed below to access the onboard control panel.
Accessing the GUI Control Panel
I. Direct Connection via Ethernet
II. Web Browser via Network Router
III. AtlasIED AZA Amplifier Discovery Tool
I. Direct Connection via Ethernet
Use this method if there is no network access available.
1. Connect an Ethernet cable from a laptop or desktop computer to the ethernet input on the AZA amplifier. Most computers will allow direct
connection from the AZA amplifier using a standard CAT5 cable.
2. Turn OFF the computer’s Wi-Fi.
3. Open a web browser, AtlasIED suggests using Google Chrome.
4. In the web browser address bar, type in the following: http://AZA804 and hit enter. For this example, we are connecting to the AZA model AZA804.
An example is shown below.
5. Out of the box the amplifier’s model number is all that is needed to connect. It is not case sensitive, but the full exact name is required.
Note: During configuration, the amplifier’s name can be changed. As an example, at a school the amplifier may be renamed “ROOM1”. After the
name is changed, follow the same process to log into the amplifier as outlined above, but change the name from “http://aza804” to “http://room1”
Alternatively, the AZA amplifier’s IP address can be directly entered into the web browser to access the AZA UI. Example: “http://192.168.1.110”.
6. The AZA UI Page will launch after pressing the “Enter” key. An example of the AZA UI page is shown below. Note: It is required to enter a
Username and Password to access the UI home page. Factory default for username is “admin” and the password is “admin”. Note: When logging
into the AZA amplifier for the first time and after entering the Factory Default username and password you will be prompted to change the
password.