Owner's Manual
Table Of Contents
- Owner’s Manual
- Table of Contents
- Important Safety Instructions
- WARNINGS
- Introduction
- Key Features
- Applications
- AZA Amplifier Configurations
- Front Panel
- Rear Panel
- Rack Ear Installation
- Finding an AZA Amplifier On a LAN
- AZA Amplifier Discovery Software
- Logging into The Amplifier The First Time
- Changing Login Username & Password For The First Time
- Resetting the Password
- AZA UI Overview
- AZA Factory Default UI Settings
- Firmware Revision
- Static IP Addresses
- Resetting the Amp to DHCP Mode
- Resetting the Login Username & Password
- Changing the Amplifier (Host) Name
- Accessory Card Installation
- Installation and Considerations
- Dimensional Drawings
- Warranty
– 12 –
AZA Series
Owner’s Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Finding an AZA Amplifier On a LAN
II. Web Browser via Network Router
This method is very similar to the Direct Connection method covered in Section 1 but uses a web browser on the local network to discover the AZA
amplifier.
1. Connect the AZA Amplifier using a standard Ethernet cable to a router. Make sure the router is in DHCP mode.
2. Connect a computer to the same router via an Ethernet cable or Wi-Fi.
3. Open a web browser, AtlasIED suggests using Google Chrome or Mozilla Firefox.
4. In the web browser address bar, type in the following: http://AZA804 and hit enter. For this example, we are connecting to the AZA model AZA804.
An example is shown below.
5. Out of the box the amplifier’s model number is all that is needed to connect. It is not case sensitive, but the full exact name is required.
Note: Once connected, the name of the amplifier can be changed to meet the install’s naming scheme.
6. The amplifier will be discovered and the AZA UI will launch after pressing the “Enter” key. An example of the AZA UI web page is shown below
Alternatively, the AZA amplifier’s IP address can be directly entered into the web browser to access the AZA UI. Example: “http://192.168.1.110”.
III. AtlasIED AZA Discovery Tool
Using this IP discovery tool is the easiest way to find and connect to any AZA amplifiers on the LAN. Visit the AtlasIED web site to download the
AZA Amplifier Discovery Tool at https://www.atlasied.com/Atmosphere/AZA/. The image below is an illustration of the discovery tool features. Click on
“Discover Amplifiers” and any AZA amps that are on the LAN will populate in a list. Select the unit to access and the IP link will take the user to the
unit’s UI login page as shown above. Note: This software will only work on a PC.
AZA Amplifier Discovery Software
This software only operates on the PC. Select the Discover Amplifier button. A list of AZA and DPA amplifiers located on the network will be shown.
Click on the IP address of the amplifier you want to connect to. You then will be taken to the web page requesting you to enter the factory default
Username (admin) and Password (admin).
AZA Amplifier Discovery Software Desktop Icon
AZA Amplifier Discovery Software