Owner's Manual
Table Of Contents
- Owner’s Manual
- Table of Contents
- Important Safety Instructions
- WARNINGS
- Introduction
- Key Features
- Applications
- AZA Amplifier Configurations
- Front Panel
- Rear Panel
- Rack Ear Installation
- Finding an AZA Amplifier On a LAN
- AZA Amplifier Discovery Software
- Logging into The Amplifier The First Time
- Changing Login Username & Password For The First Time
- Resetting the Password
- AZA UI Overview
- AZA Factory Default UI Settings
- Firmware Revision
- Static IP Addresses
- Resetting the Amp to DHCP Mode
- Resetting the Login Username & Password
- Changing the Amplifier (Host) Name
- Accessory Card Installation
- Installation and Considerations
- Dimensional Drawings
- Warranty
– 15 –
AZA Series
Owner’s Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
AZA UI Overview
8. Amplifier Output Load Configurations
Configure the amplifier outputs to be either 70V / 100V or 4Ω / 8Ω. Amplifier output selections are in pairs. Note: Factory default CH1, CH2, CH 3,
CH 4 are set to 70V.
9. Auto Power Down (APD) Button
Auto Power Down (APD) Enable / Disable. When this box is checked the unit is in Auto Power Down (APD) mode. After 30 minutes with no audio
signal at the amplifier, the AZA amplifier will enter Standby APD Mode. In Standby APD Mode the amplifier will draw less power. The AZA amplifier
has three states of idle power consumption to meet installation energy power consumption requirements. Refer to the amplifier specifications page
in this manual for power consumption data. Refer to the section on “Understanding the 3 AC Power Consumption Idle States” for a definition on
how each idle state operates. When the amplifier senses signal on any of the inputs, the amplifier will automatically switch from APD Mode to Active
Mode. Note: APD is not enabled by default.
10. Front Panel Power Switch Disable Button
When selecting this box, the front panel power switch is disabled. The amplifier can only be turned On / Off through the web UI or by removing the
power cord. Note: The front panel power button is enabled by default.
11. Advance Settings Button
This button will take you to the advanced section of the UI. This section allows you access to I/0 Routing, Output EQ, Delay, Output Level, Output
Limiters, Control Port Assignment and accessory card initialization. Note: If you are using the amplifier with an Atmosphere Zone Master, these
features are not needed. Refer to the AZA404 & AZA804 Advanced Settings Manual located at https://www.atlasied.com/Atmosphere/AZA/
AZA Factory Default UI Settings
• Output Load Selection: CH 1, 2, 3, 4 set to 70V
• Auto Power Down (APD) is Disabled
• Front Panel Power Switch is Enabled
3 4 5 6 7 8 9 10