Owner's Manual

– 20 –
AZA Series
Owner’s Manual
AtlasIED.com
TELEPHONE: [phone]
[e-mail]
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Status Indicators
Power Blue
Standby (Remote Turn ON) Blinking Blue, Front Panel Only
Output Signal Green
LED Bar Meter GUI Only
Output Limit / Protect Red
4Ω / 8Ω Yellow, CH 1/2 & CH 3/4
70V / 100V Operation Yellow, CH 1/2 & CH 3/4
Output Mute Status Flashing Red
DSP Elements
IO Routing Matrix Mixer
Hi & Low Pass Filters One Per Output, Adjustable Slopes and Frequencies
EQ 5 Parametric Filters Per Output
Delay 60mS Per Output
Limiter Each Output up to 12dB of Assignable Limiting
DSP Frequency Type 48k, 24bit
Interface Control Ports
USB No
Ethernet GUI Access, RJ45 Rear Panel
Wi-Fi No
Bluetooth No
GPIO Ports
Location Rear
GPIO Ports Qty 4, Remote Level & Mute Functions, Assignable, PHX Connector
Connection Euro Block PHX Type 3.5mm, 6 Pins, Ground, +10VDC, C1, C2, C3, C4
Functions Mute, Remote Level (Assignable)
Output Terminals (Speaker)
Output Connectors Type Screw Terminal Barrier Strip with Cover
Output Connectors Number of Terminals 8, M4 Thread
Output Connectors Fixed or Removable Fixed
Wire Size 18-10 AWG When Using Yellow Spade Lug 0.250 Terminal, Qty 8 Included (Class 3 Wiring Required)
Terminal Spacing 0.300" (7.62mm)
Current Rating 25A per Terminal
Cooling
APD Standby, Active Idle Convection Cooled
In Use Convection Cooled with Variable Speed Fan Assist
Cooling Air Flow Direction Rear to Front
Electrical Specications (General)
Total Harmonic Distortion 1 kHz and 1dB
Below Rated Power
Typical, 0.2%
Frequency Response 20Hz - 20kHz (DSP Filters Set to Flat)
Signal to Noise Ratio >100dB Below Rated Output (A-weighted)
Damping Factor (20Hz to 400Hz) 100 (Measurement is Limited Due To DSP)
Slew Rate 40Vus
Crosstalk 73dB @ 1KHz, CH1-2 & CH 2-1, CH3-4 & CH4-3
Protection Hi / Low Input Voltage, Thermal, Short, Over Current
Max Output Peak Voltage 100V Mode 140V
Max Output Peak 4Ω Mode
AZA404: 3.5A
AZA804: 7A