Owner's Manual
Table Of Contents
- User Manual
- Table of Contents
- Important Safety Instructions
- Introduction
- Key Features and Applications
- Package Contents
- Rack Installation Guide
- Hardware Overview
- Connections
- Network Connection Overview
- Software Overview
- Sources
- Zones (Zone Outputs)
- Zones-Limiter
- Zones-Groups Overview
- Room Combine Active
- Message Player Overview
- Messages
- GPIO Overview
- Scenes Overview
- Routines Overview
- Accessories Overview
- Accessories Page
- Print, Assemble, Place, and Scan
- X-ANS General Settings
- Accessories Connection Rules
- Scheduler, Steps to Create an Event
- Diagrams – Connection Diagram and Block Diagram
- Settings Page Overview
- Front Panel Display Menu Tree
- Specifications
- Mechanical Line Drawings with Dimensions
- Regulatory Information: AZM4 / AZM8 / A-BT
- Limited Warranty, Customer Service Online Warranty Claim Process
- Quick Start Guide
- Product Info
- System Examples
Atmosphere
User Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
– 17 –
RCA Inputs - Mono
1. Displays rear panel and identifies physical location of the RCA mono-summed input for wiring. Navigation tabs for Gate, De-Esser, Compressor,
Equalizer, and Auto-Gain. (same as Mic/Line).
2. Shows input type and port select, “Change Type or Ports” to re-configure if desired.
3. Pre-set High Pass Filter Enable – a separate EQ filter placed before the Equalizer page allowing roll-off of low end before the gate and compressor,
allowing all bands of the equalizer to be used for other requirements.
4. 0dB to +30 dB of preamp gain available to fine tune RCA input sensitivity sources.
5. When in the General Settings page, editing of the source name, color tag (click on color), and also delete source “X”, is available.
Stereo Sources
Mic/Line - Stereo
1. Mic/Line Stereo sources require selecting a Left and Right input port which can be any available Mic/Line Inputs.
2. Pre-set High Pass Filter Enable for Left & Right – a separate EQ filter placed before the Equalizer page allowing roll-off of low end before the gate
and compressor, allowing all bands of the equalizer to be used for other requirements. NOTE: In Stereo Mode, the DSP will affect both left & right
channels automatically.
3. 0dB to +60 dB of preamp gain available to fine tune input sensitivity.
4. When in the General Settings page, editing of the source name, color tag (click on color), and also delete source “X”, is available.