Owner's Manual
Table Of Contents
- User Manual
- Table of Contents
- Important Safety Instructions
- Introduction
- Key Features and Applications
- Package Contents
- Rack Installation Guide
- Hardware Overview
- Connections
- Network Connection Overview
- Software Overview
- Sources
- Zones (Zone Outputs)
- Zones-Limiter
- Zones-Groups Overview
- Room Combine Active
- Message Player Overview
- Messages
- GPIO Overview
- Scenes Overview
- Routines Overview
- Accessories Overview
- Accessories Page
- Print, Assemble, Place, and Scan
- X-ANS General Settings
- Accessories Connection Rules
- Scheduler, Steps to Create an Event
- Diagrams – Connection Diagram and Block Diagram
- Settings Page Overview
- Front Panel Display Menu Tree
- Specifications
- Mechanical Line Drawings with Dimensions
- Regulatory Information: AZM4 / AZM8 / A-BT
- Limited Warranty, Customer Service Online Warranty Claim Process
- Quick Start Guide
- Product Info
- System Examples
Atmosphere
User Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
– 55 –
Messages Page
1. Select Messages tab to open.
2. Select the messages you want available for control from the C-ZSV and-or virtual mobile device.
3. The light bulb locate icon can be clicked on or off causing the connected device to flash to physically identify its location. If left on, it will automatically
shut off after 30 minutes, or will cancel when the controller encoder is used. If you see the QR code symbol and click on it, a QR code will display
allowing a mobile virtual controller to emulate the wall plate controller.
Actions Page
1. Open Actions page
2. Select from the list of pre-configured routines to be included on C-ZSV and mobile device.
3. Select from the list of pre-configured scenes to be included on C-ZSV and mobile device.
4. Select from the list of pre-configured GPO presets to be included on C-ZSV and mobile device.
5. Bell Scheduler change – When enabled, this lets you make an on-the-spot change to the current day’s schedule.
6. The light bulb locate icon can be clicked on or off and will cause the connected device to flash to physically identify its location. If left on, it will
automatically shut off after 30 minutes or will cancel when the controller encoder is used. If you see the QR code symbol and click on it, a
QR code will display allowing a mobile virtual controller to emulate the wall plate controller.