Owner's Manual
Table Of Contents
- User Manual
- Table of Contents
- Important Safety Instructions
- Introduction
- Key Features and Applications
- Package Contents
- Rack Installation Guide
- Hardware Overview
- Connections
- Network Connection Overview
- Software Overview
- Sources
- Zones (Zone Outputs)
- Zones-Limiter
- Zones-Groups Overview
- Room Combine Active
- Message Player Overview
- Messages
- GPIO Overview
- Scenes Overview
- Routines Overview
- Accessories Overview
- Accessories Page
- Print, Assemble, Place, and Scan
- X-ANS General Settings
- Accessories Connection Rules
- Scheduler, Steps to Create an Event
- Diagrams – Connection Diagram and Block Diagram
- Settings Page Overview
- Front Panel Display Menu Tree
- Specifications
- Mechanical Line Drawings with Dimensions
- Regulatory Information: AZM4 / AZM8 / A-BT
- Limited Warranty, Customer Service Online Warranty Claim Process
- Quick Start Guide
- Product Info
- System Examples
Atmosphere
User Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
– 66 –
2. Network
The left panel is the wired connection and the right panel is the wireless connection. Both can be connected at the same time, with different IP
addresses. In addition, the wireless can be configured as an access point to directly connect to the UI when a network isn’t available. This is useful
when setting up the device prior to being on-site for install or if the site doesn’t yet have an active connection. Default setting is DHCP. To set up
Static IP, enter the address, subnet mask, and default gateway, then press “UPDATE”. A popup message will verify you want to reboot to save
configuration. The IP address is displayed at the top of the front panel display.
3. Firmware
To review the firmware version and update if needed. It is recommended to save a backup configuration file prior to updating.
Visit atlasied.com to download the latest firmware.