Owner's Manual
Table Of Contents
- User Manual
- Table of Contents
- Important Safety Instructions
- Introduction
- Key Features and Applications
- Package Contents
- Rack Installation Guide
- Hardware Overview
- Connections
- Network Connection Overview
- Software Overview
- Sources
- Zones (Zone Outputs)
- Zones-Limiter
- Zones-Groups Overview
- Room Combine Active
- Message Player Overview
- Messages
- GPIO Overview
- Scenes Overview
- Routines Overview
- Accessories Overview
- Accessories Page
- Print, Assemble, Place, and Scan
- X-ANS General Settings
- Accessories Connection Rules
- Scheduler, Steps to Create an Event
- Diagrams – Connection Diagram and Block Diagram
- Settings Page Overview
- Front Panel Display Menu Tree
- Specifications
- Mechanical Line Drawings with Dimensions
- Regulatory Information: AZM4 / AZM8 / A-BT
- Limited Warranty, Customer Service Online Warranty Claim Process
- Quick Start Guide
- Product Info
- System Examples
Atmosphere
User Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
– 27 –
Mixes
1. The “Mixes” source provides four separate Mix Channels each allowing a selection of any source inputs to be combined into a sub-mix channel with a
single audio master fader adjustment.
2. Select ADD MIX to add and configure a Mix Channel.
1. Each Mix can be named here and will be available to any zone by selecting from the zone inputs source lists.
2. Select input sources for Mix 1 channel.
3. The “X” deletes the mix and is only available in mix settings. Input level adjust – move fader or enter in dB level desired in window. When signal is
present, fader animates as a pre-fader peak meter and shows: Green = signal activity, Red = clipping. Note: Pay close attention to gain structure when
combining several sources.
Input Mix Page
1. Each Mix channel has a “Show Sources” options. When selected it drops down each source and fader for mixing, when done, “Hide Sources”
retracts sources and only displays the master mix fader.
2. This “>” icon opens the settings page to select or un-select sources to include in group mix.
3. Mix each level to desired group mix.
4. Mute – select to mute input channel.
5. Set level of master mix (Mix 1) to output (each of the 4 Mix channels appear in the source list in zone outputs).