Owner's Manual
Table Of Contents
- User Manual
- Table of Contents
- Important Safety Instructions
- Introduction
- Key Features and Applications
- Package Contents
- Rack Installation Guide
- Hardware Overview
- Connections
- Network Connection Overview
- Software Overview
- Sources
- Zones (Zone Outputs)
- Zones-Limiter
- Zones-Groups Overview
- Room Combine Active
- Message Player Overview
- Messages
- GPIO Overview
- Scenes Overview
- Routines Overview
- Accessories Overview
- Accessories Page
- Print, Assemble, Place, and Scan
- X-ANS General Settings
- Accessories Connection Rules
- Scheduler, Steps to Create an Event
- Diagrams – Connection Diagram and Block Diagram
- Settings Page Overview
- Front Panel Display Menu Tree
- Specifications
- Mechanical Line Drawings with Dimensions
- Regulatory Information: AZM4 / AZM8 / A-BT
- Limited Warranty, Customer Service Online Warranty Claim Process
- Quick Start Guide
- Product Info
- System Examples
Atmosphere
User Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
– 30 –
Zone - Priority
The Input Priority page allows you to rank audio sources for each zone by importance to mitigate a conflict where two sources try to play at the same time.
The higher priority source will always play over the lower priority source.
1. The High Priority GPI is permanently set to the highest priority.
2. Message Player– select the “swap” button to arrange whether Msg Player or RMS Ducker has higher priority after GPI HP input. The top
selection is highest priority.
3. Priority Input Source Selection and Priority Threshold – when the selected priority input source’s RMS levels exceed the priority threshold, the
priority source will duck the normal input source channels.
4. Zone routed sources are permanently set to lowest priority.
5. The ducker dynamic settings are common for all channels and are adjustable here and also accessible via Settings > Device Settings.
6. Priority input status indicator- will light yellow when the priority source is actively ducking the main source. It will be grey when inactive.
Zone – Crossover
1. T h
e Crossover provides a HighPass and LowPass adjustable filter for Main (Mono and Stereo source) and when Sub is added, an additional
HighPass and Lowpass just for the subwoofer. Dynamically move graphic or select and enter settings.
2. Enable-Bypass for each filter, helps to audition the changes.
3. Chose HP and LP presets by type (Butterworth or Linkwitz Riley) and Slope/Octave: BW6dB, BW12dB, BW18dB, BW24dB, LR12dB, LR24dB